ttamamusually replies in minutes11:42
pinnedtypical AED 100–500on site 1–3 hoursarea Meydanbooking app · whatsapp
need furniture assembly in meydan — today if possible11:42✓✓
For anyone arranging handyman around Meydan, tamam removes the two annoying parts — finding someone trustworthy, and finding out the price before they arrive.11:43
typical ranges vendors quote around meydan —TV mounting up to 65 inches (bracket supplied by customer)AED 150–350Curtain rail or blind installation, per windowAED 100–250Flat-pack assembly, standard bed or chest of drawersAED 150–30011:44
that works. who actually turns up?11:45✓✓
licensed vendors only — the licence and vendor ID land in this chat before anyone rings your bell.11:46
TV mounting: forget the stud finder you saw on YouTube
Most TV-mounting advice online is written for North American timber-frame houses. UAE apartments and villas are built differently: exterior and structural walls are concrete block or poured concrete finished with plaster, while many internal partitions, especially in towers built after roughly 2005, are gypsum board on light-gauge metal studs. A timber stud finder is useless here. The professional method is a knock test first (block sounds dead, gypsum sounds hollow), then a magnet or metal-stud detector to map the studs at their usual 400 or 600 millimetre spacing.
On block or concrete, the job is straightforward: a hammer drill with a 6 or 8 millimetre masonry bit, nylon plugs matched to the screw, and the bracket pulls up rock solid. Expect 45-60 minutes for a fixed or tilting mount up to 65 inches, including unboxing, levelling and cable tidy-up. On gypsum, the calculus changes. A fixed mount for a mid-size TV can go onto heavy-duty toggle anchors spread across the plate, but a full-motion articulating arm concentrates leverage onto a few fixing points, and on gypsum that demands hitting at least two metal studs or, better, fitting a plywood backing board first. A technician who proposes screwing a swing arm straight into plasterboard with plastic plugs is telling you they have not done this long.
Judging the finished work: the five-minute walkthrough before the van leaves
Every job in this guide has an objective pass test, and the time to apply it is while the technician is still in your home. Pull firmly on every bracket, rail and mount, a proper fixing does not move at all, and a professional will do this pull test in front of you without being asked. Sight along rails and frames or ask for the laser to be held up one last time. Open and close every adjusted door at normal speed. Run a finger along silicone lines to check the edges are bonded (gently, and only if the bead has skinned). Count the holes: there should be exactly as many as there are fixings, and any abandoned holes should have been filled before the tools were packed.
Then look down. Dust and packaging are part of the job, not your problem after it: block-drilling dust vacuumed rather than swept into grout lines, cardboard and offcuts removed, protective film peeled off new hardware. Take photos of the finished work while everything is fresh, they are useful if anything settles or loosens in the first weeks.
AED ranges
Rather than publishing one rate, tamam shows what multiple verified vendors charge for furniture assembly so you can pick the tier that fits the job and the budget.
TV mounting up to 65 inches (bracket supplied by customer)AED 150–350
Curtain rail or blind installation, per windowAED 100–250
Flat-pack assembly, standard bed or chest of drawersAED 150–300
Large wardrobe assembly with anti-tip anchoringAED 250–500
Half-day multi-job or move-in snag visitAED 300–500
The range narrows to an actual figure once a vendor sees the scope. You approve it before work starts.
Frequently asked questions
Can a handyman do electrical or plumbing work?
Only at fixture level: swapping a light fitting, changing a tap washer, fitting an appliance. New wiring, new power points, anything at the distribution board, or work on supply pipework needs a licensed electrician or plumber under DEWA, SEWA or ADDC and municipality rules. A good handyman will tell you where that line is rather than crossing it.
Can I hang a heavy mirror on a gypsum wall?
Yes, if it is fixed correctly. Light frames go on plasterboard anchors, but a heavy mirror needs to land on the metal studs behind the board or use rated cavity fixings across multiple points. If the technician cannot tell you which method they are using and why, pause the drilling.
How long before I can use the shower after silicone resealing?
Roughly 24 hours. Sanitary silicone skins quickly but needs a full day to cure; running the shower the same evening washes out the bead and shortens its life dramatically. Book the reseal for a morning and plan around the guest bathroom that day.
How far ahead should I book?
In Dubai, Sharjah and Abu Dhabi, next-day slots are usually realistic and same-day is possible for simple jobs. In RAK, Fujairah and UAQ, where many teams travel from other emirates, one to two days ahead is safer. Move-in season, September and the weeks around school start, tightens availability everywhere.
What happens if the job takes longer than quoted?
It depends on whether the scope changed. If you added tasks on the day, expect the price to move, agree the addition before the extra work starts. If the scope is unchanged and the technician simply underestimated, a fixed quote should hold, which is one reason to get quotes against a full photo-documented list rather than a vague description.
Do you cover Meydan?
Yes — Meydan is covered across Dubai, with vendors who regularly work the area. Availability shows live in the app.
Common missteps
Booking one small job at a time
Every visit carries the call-out minimum, so three single-job bookings can cost more than one half-day visit that clears ten jobs. Keep a running list on your phone and book when it reaches three or four items. Vendors also quote batched work more competitively because their travel time is spread across more billable tasks.
Letting anyone seal over old silicone
New silicone does not bond to old silicone, and mould trapped underneath grows straight through the fresh bead. If the technician is not spending most of the job on removal and drying, the reseal will fail within months. Ask to see the joint clean and dry before the new bead goes in.
Judging the quote instead of the method
The cheapest quote often prices a different job: silicone over silicone, plugs instead of proper anchors, no anti-tip strap on the wardrobe. When quotes differ widely, ask each vendor how they will do the job. The one who mentions wall type, anchors and cure times without prompting is usually the one worth paying.