ttamamusually replies in minutes11:07
pinnedtypical AED 100–500on site 1–3 hoursarea The Galleria Al Maryahbooking app · whatsapp
need shelf installation in the galleria al maryah — today if possible11:07✓✓
tamam covers The Galleria Al Maryah for handyman the same way it covers every UAE community: multiple vetted vendors, AED ranges you can see up front, and booking that takes a couple of taps.11:08
typical ranges vendors quote around the galleria al maryah —Standard call-out including first hour of labourAED 100–200TV mounting up to 65 inches (bracket supplied by customer)AED 150–350Curtain rail or blind installation, per windowAED 100–25011:09
that works. who actually turns up?11:10✓✓
licensed vendors only — the licence and vendor ID land in this chat before anyone rings your bell.11:11
The kit in the van: what a properly equipped handyman carries
You can read a technician's standards from their kit before they touch a wall. The baseline for UAE work is a cordless hammer drill with masonry, wood and metal bits; a drill-driver with a clutch for flat-pack work; a cross-line laser and a traditional spirit level; a metal-stud detector and a strong magnet; and an anchor box that covers the local reality, nylon plugs in several sizes, plasterboard self-drives, toggles, cavity fixings and at least a few chemical-anchor options for hollow block.
The finishing and protection layer matters just as much: drop sheets, masking tape, a handheld vacuum or dust-catch attachment, sanitary silicone with a proper gun and tooling kit, hardwood dowels and wood glue for stripped hinges, and a step platform or ladder rated for ceiling work. What the technician usually does not carry is your specific hardware: TV brackets, curtain rails, mirrors and shelves are normally customer-supplied unless you agree otherwise in the quote, so confirm who buys what before the visit, not at your doorstep.
Judging the finished work: the five-minute walkthrough before the van leaves
Every job in this guide has an objective pass test, and the time to apply it is while the technician is still in your home. Pull firmly on every bracket, rail and mount, a proper fixing does not move at all, and a professional will do this pull test in front of you without being asked. Sight along rails and frames or ask for the laser to be held up one last time. Open and close every adjusted door at normal speed. Run a finger along silicone lines to check the edges are bonded (gently, and only if the bead has skinned). Count the holes: there should be exactly as many as there are fixings, and any abandoned holes should have been filled before the tools were packed.
Finally, keep the relationship. Handyman work is the most repeat-heavy trade in home services, there is always a next list, and a technician who already knows your wall types and building rules is measurably faster on visit two. If the work passed your walkthrough, rebook the same vendor next time; tamam keeps the vendor attached to your booking history so the same team can come back, and you can coordinate the details over whatsapp rather than re-explaining your building from scratch.
What you should expect to pay
Rather than publishing one rate, tamam shows what multiple verified vendors charge for shelf installation so you can pick the tier that fits the job and the budget.
Standard call-out including first hour of labourAED 100–200
TV mounting up to 65 inches (bracket supplied by customer)AED 150–350
Curtain rail or blind installation, per windowAED 100–250
Large wardrobe assembly with anti-tip anchoringAED 250–500
Full shower or bathroom silicone resealAED 200–400
These bands reflect typical jobs. Unusual scope gets quoted individually, still before you commit.
Frequently asked questions
Do handymen bring their own tools and materials?
Tools, yes, always: drills, levels, anchors and consumables like screws and basic plugs are part of the service. Specific hardware is different: TV brackets, curtain rails, mirrors, shelves and replacement hinges are normally customer-supplied unless the quote says otherwise. Confirm the split when you accept the quote so nobody is standing in a hardware store mid-visit.
Can a handyman do electrical or plumbing work?
Only at fixture level: swapping a light fitting, changing a tap washer, fitting an appliance. New wiring, new power points, anything at the distribution board, or work on supply pipework needs a licensed electrician or plumber under DEWA, SEWA or ADDC and municipality rules. A good handyman will tell you where that line is rather than crossing it.
Do I need building permission before a handyman can drill?
In many Dubai and Abu Dhabi towers and masterplanned communities, yes: management requires a work permit or NOC, and often restricts noisy work to set weekday hours. Villas and most older buildings need nothing formal beyond a word with the watchman. Check with your building before booking, because a technician turned away at security still counts as a visit.
Is it cheaper to combine several small jobs in one visit?
Significantly. The call-out minimum, typically AED 100-200, is charged per visit, so five separate bookings pay that floor five times. A batched list turns the same jobs into one half-day visit around AED 300-500, and vendors quote batched work more keenly because the travel is amortised.
What happens if the job takes longer than quoted?
It depends on whether the scope changed. If you added tasks on the day, expect the price to move, agree the addition before the extra work starts. If the scope is unchanged and the technician simply underestimated, a fixed quote should hold, which is one reason to get quotes against a full photo-documented list rather than a vague description.
Do you cover The Galleria Al Maryah?
We cover The Galleria Al Maryah and the surrounding Abu Dhabi communities. Message on whatsapp if you want a specific time confirmed first.
Avoid these
Letting anyone seal over old silicone
New silicone does not bond to old silicone, and mould trapped underneath grows straight through the fresh bead. If the technician is not spending most of the job on removal and drying, the reseal will fail within months. Ask to see the joint clean and dry before the new bead goes in.
Putting a full-motion TV arm into bare plasterboard
An articulating arm multiplies the TV's weight into leverage at a few fixing points, and plastic plugs in gypsum cannot resist it. The mount holds during the demo and fails weeks later. Insist on metal studs, a backing board, or a different wall.
Judging the quote instead of the method
The cheapest quote often prices a different job: silicone over silicone, plugs instead of proper anchors, no anti-tip strap on the wardrobe. When quotes differ widely, ask each vendor how they will do the job. The one who mentions wall type, anchors and cure times without prompting is usually the one worth paying.