tamam › home › handyman › shelf installation in liwan 2
For anyone arranging handyman around Liwan 2, tamam removes the two annoying parts — finding someone trustworthy, and finding out the price before they arrive.
Anyone who has arranged handyman in Liwan 2 knows the friction isn't the work itself — it's coordination. Vendors familiar with the area cut that down considerably.
Vendor availability is steady and lead times are typically short. Typical on-site time is 1–3 hours. Vendors will flag it in advance if your job looks heavier than standard.
Floating and bracketed shelving anchored for real loads.
open tamam and search shelf installation
set the address and any access instructions
shortlist by rating, price band or availability
confirm the window
rate afterwards so the next booking is faster
There is no single correct price for shelf installation — there is a range, and where you land in it depends on scope and which vendor you pick. The app shows you that range up front.
The range narrows to an actual figure once a vendor sees the scope. You approve it before work starts.
AED 100–500
Curtain work is 80 percent measurement and 20 percent drilling, and the mistakes all happen in the first part. The technician has to establish three things before a single hole is made: whether the fixing is face-fix (into the wall above the window), ceiling-fix (up into the slab), or inside the recess; whether the ceiling at that point is actual concrete slab or a suspended gypsum ceiling with a void above it; and how much the finished curtains will weigh. A double track carrying blackout plus sheer across a three-metre villa window is a genuinely heavy, constantly moving load, and it needs brackets every 60-80 centimetres, not just one at each end.
Time budget: a straightforward single rail or roller blind is 30-45 minutes per window; a ceiling-fixed double track with careful levelling runs closer to an hour. The finished check is simple: the rail is dead level (water finds crooked rails instantly, your eye takes a day), gliders run end to end without catching, and the brackets do not flex when you draw the curtain briskly.
Two ways in: the app for comparison and tracking, whatsapp if you would rather just talk to someone.
Every hanging job starts with the same question: what is this wall? Gypsum partition takes self-drive plasterboard anchors happily for light frames, up to roughly five kilograms per point, and spring toggles or metal cavity anchors for heavier pieces; anything genuinely heavy, a large mirror, a floating shelf meant to carry books, should land on the metal studs. Solid block or concrete takes standard nylon plugs and holds almost anything, the only cost being a hammer drill and some dust management.
The surprise is hollow block, common in older and mid-market buildings across the northern emirates and in plenty of Dubai and Sharjah stock from the 1990s and 2000s. The drill punches through the block face into a void, the plug spins uselessly, and an inexperienced installer just moves over ten centimetres and tries again, leaving a trail of holes. The correct answers are longer plugs that grip the far face, umbrella-style cavity fixings, or for heavy mirrors and cabinets, a chemical anchor with a mesh sleeve that mushrooms resin inside the void. This is exactly the kind of judgement you are paying a professional call-out for.
The handyman's list is everything the developer never owed you: mounting TVs and mirrors, curtain tracks in every room, wardrobe extras, child locks, shelf installation, appliance levelling, door stoppers before the first wall dent, and the dozens of small adjustments that turn a bare unit into a working home. The professional way to run this is room by room with a written list, exactly as a site foreman walks a punch list: start at the front door, work clockwise, note wall types as you go, and group the jobs by tool so the technician drills everything in one dusty phase rather than unpacking the hammer drill four times.
For a full move-in list, a half-day booking (around AED 300-500 in most of the market) is far better value than three separate call-outs, and it is where an organised customer saves real money. Send the full list with photos when you request quotes, vendors on tamam can price a batched visit properly only if they can see the whole scope, and a vague 'a few small jobs' brief reliably produces either an inflated quote or a second visit.
Every visit carries the call-out minimum, so three single-job bookings can cost more than one half-day visit that clears ten jobs. Keep a running list on your phone and book when it reaches three or four items. Vendors also quote batched work more competitively because their travel time is spread across more billable tasks.
New silicone does not bond to old silicone, and mould trapped underneath grows straight through the fresh bead. If the technician is not spending most of the job on removal and drying, the reseal will fail within months. Ask to see the joint clean and dry before the new bead goes in.
The cheapest quote often prices a different job: silicone over silicone, plugs instead of proper anchors, no anti-tip strap on the wardrobe. When quotes differ widely, ask each vendor how they will do the job. The one who mentions wall type, anchors and cure times without prompting is usually the one worth paying.
Dubai's tower-heavy stock means the building, not the emirate, sets most of the rules. Marina, JLT, Downtown and Business Bay towers commonly require a work permit or NOC from building management before a technician drills anything, plus contractor access through the service lift during set hours, often 9am to 6pm on weekdays only. Factor the permit lead time into your booking, and remember that post-2005 towers are heavy on gypsum partitions, so brief heavy-mounting jobs accordingly. Anything touching electrical circuits or water supply beyond simple fixtures crosses into DEWA and Dubai Municipality licensed-trade territory.
The vetting happens before a vendor is listed — municipality licence, valid insurance, identifiable staff — so the comparison you make is between businesses that already cleared the bar.
Only at fixture level: swapping a light fitting, changing a tap washer, fitting an appliance. New wiring, new power points, anything at the distribution board, or work on supply pipework needs a licensed electrician or plumber under DEWA, SEWA or ADDC and municipality rules. A good handyman will tell you where that line is rather than crossing it.
Yes, if it is fixed correctly. Light frames go on plasterboard anchors, but a heavy mirror needs to land on the metal studs behind the board or use rated cavity fixings across multiple points. If the technician cannot tell you which method they are using and why, pause the drilling.
In many Dubai and Abu Dhabi towers and masterplanned communities, yes: management requires a work permit or NOC, and often restricts noisy work to set weekday hours. Villas and most older buildings need nothing formal beyond a word with the watchman. Check with your building before booking, because a technician turned away at security still counts as a visit.
In Dubai, Sharjah and Abu Dhabi, next-day slots are usually realistic and same-day is possible for simple jobs. In RAK, Fujairah and UAQ, where many teams travel from other emirates, one to two days ahead is safer. Move-in season, September and the weeks around school start, tightens availability everywhere.
They can, but often should not, yet. Genuine construction defects belong on the developer's snag list inside the defects liability period, usually twelve months, and fixing them privately can weaken your claim. Document defects with the developer first, then use a handyman for everything the developer never owed you: mounting, rails, assembly and the move-in list.
We cover Liwan 2 and the surrounding Dubai communities. Message on whatsapp if you want a specific time confirmed first.