ttamamusually replies in minutes11:35
pinnedrange AED 150–600time needed 1–3 hoursserving Executive Towersbook via app or whatsapp
need light installation in executive towers — today if possible11:35✓✓
tamam connects Executive Towers households and businesses with vetted electrician providers. You see the options, the AED range and the availability, then book directly.11:36
typical ranges vendors quote around executive towers —Socket or switch replacement, per pointAED 150–250New socket point as a spur on an existing circuitAED 180–350Light fixture or ceiling fan installation, standard ceilingAED 150–35011:37
that works. who actually turns up?11:38✓✓
licensed vendors only — the licence and vendor ID land in this chat before anyone rings your bell.11:39
Where a handyman stops and an approved contractor begins
UAE utilities draw a firm line through every home. DEWA, SEWA, ADDC and Etihad WE own and control everything up to and including the meter; nobody you hire may touch it, and a damaged meter seal alone can trigger penalties. Beyond the meter, the rule of thumb is that like-for-like work is handyman territory while anything that changes the installation needs a contractor holding the relevant utility approval: replacing or upgrading the DB itself, adding new circuits, rewiring, increasing the connected load for a bigger AC or an EV charger, or anything the utility must inspect and reconnect.
The boundary matters for more than compliance. Home insurance can walk away from a fire claim traced to unapproved modification of the fixed installation, and villa owners feel it at resale, when a buyer's inspection flags a DB full of undocumented additions. If a vendor quotes you for a load increase or a DB replacement without mentioning utility approval or an inspection step, that is your cue to ask harder questions or find another vendor.
What you should expect to pay
Rather than publishing one rate, tamam shows what multiple verified vendors charge for light installation so you can pick the tier that fits the job and the budget.
Socket or switch replacement, per pointAED 150–250
New socket point as a spur on an existing circuitAED 180–350
Light fixture or ceiling fan installation, standard ceilingAED 150–350
RCD or breaker replacement in the DBAED 200–450
Villa landscape lighting repair visitAED 250–550
Parts and consumables, where they apply, are quoted separately and approved by you first.
What goes wrong
Fixing nuisance trips by fitting a bigger breaker or a less sensitive RCD
Upsizing protection to stop tripping removes the safeguard while leaving the fault. An oversized MCB lets cables run hotter than they are rated for inside walls, and a desensitised RCD stops protecting people from a leaking water heater. Any vendor proposing this as the fix is the wrong vendor.
Booking tower work without checking permit rules first
Many managed buildings turn contractors away without a work permit or landlord NOC, and some restrict noisy work to weekday hours. The result is a paid visit that ends in the lobby. One message to building management before you pick a slot avoids the wasted call-out.
Treating outdoor electrics like indoor electrics
Indoor-grade junction boxes in flowerbeds, unrated extension cords feeding garden lights and balcony sockets without covers all fail the same way: moisture gets in, the RCD starts tripping, and the search for the wet joint costs more than proper IP-rated fittings would have. Outdoors, specification is the economy.
Frequently asked questions
Can a handyman add a new socket, or does that need DEWA approval?
A socket added as a spur from an existing nearby circuit is handyman-level work and needs no utility involvement, though in a rental you need landlord permission for anything cut into walls. A new circuit from the DB, a board upgrade or an increase in connected load crosses into approved-contractor territory with DEWA, SEWA, ADDC or Etihad WE, depending on your emirate.
My whole flat lost power but the neighbours are fine. Who do I call?
First check your own DB: if the main isolator or RCD has dropped, reset it once. If the board is fully on but the flat is dead, the fault is likely at the meter or the building's riser, which is the utility's or building management's side. Call the building's maintenance desk or the utility's fault line; a private electrician cannot legally open that part of the installation.
Are my 110V appliances from the US safe to use here?
Not directly. The UAE supply is 220–240V, and plugging a 110V appliance in without a step-down transformer will damage it, often immediately. Small dual-voltage electronics like laptop chargers are fine with a plug adapter, but motors, kitchen appliances and anything with a heating element need a correctly rated transformer or, more sensibly, a local replacement.
What is an RCD, and why does mine trip when the washing machine runs?
An RCD cuts power within milliseconds when current leaks to earth, which is what stops a faulty appliance from electrocuting someone. Washing machines trip it when their heating element's insulation degrades, a very common failure in the UAE's hard water conditions. The fix is repairing or replacing the appliance, never swapping the RCD for a less sensitive one.
Can electricians work evenings or weekends in apartment towers?
Emergency fault attendance is generally allowed at any hour, but planned noisy work like drilling is restricted by most building managements to weekday daytime slots, commonly somewhere between 8am and 6pm. Quiet work such as fixture swaps or DB diagnosis is often fine in the evening. Confirm your building's rules before booking a time you cannot use.
Do you cover Executive Towers?
Executive Towers is within our Dubai coverage. Open the app to see which vendors have slots near you today.