ttamamusually replies in minutes11:00
pinnedfrom AED 150–600visit length 1–3 hourslocation Al Markaziyah East, Abu Dhabivendors verified
need light installation in al markaziyah east — today if possible11:00✓✓
For anyone arranging electrician around Al Markaziyah East, tamam removes the two annoying parts — finding someone trustworthy, and finding out the price before they arrive.11:01
typical ranges vendors quote around al markaziyah east —Socket or switch replacement, per pointAED 150–250New socket point as a spur on an existing circuitAED 180–350Light fixture or ceiling fan installation, standard ceilingAED 150–35011:02
that works. who actually turns up?11:03✓✓
licensed vendors only — the licence and vendor ID land in this chat before anyone rings your bell.11:04
Cost of light installation
Rather than publishing one rate, tamam shows what multiple verified vendors charge for light installation so you can pick the tier that fits the job and the budget.
Socket or switch replacement, per pointAED 150–250
New socket point as a spur on an existing circuitAED 180–350
Light fixture or ceiling fan installation, standard ceilingAED 150–350
RCD or breaker replacement in the DBAED 200–450
Villa landscape lighting repair visitAED 250–550
You will see each vendor's price against your job description, then decide. No commitment until then.
The landlord between tenants: a two-hour audit that prevents deposit disputes
The gap between tenancies is the only time you have an empty unit, full access and no one to inconvenience, which makes it the cheapest possible moment to deal with electrical wear. Faults found now cost a call-out; the same faults found by an unhappy tenant in month two cost a call-out plus an argument about liability, and unresolved snags are a recurring theme in deposit disputes at the rental committees.
A competent electrician can audit a one- or two-bedroom flat in a couple of hours: test every socket with a tester, press-test each RCD, check water heater elements for earth leakage before they become the next tenant's mystery trip, tighten DB terminals that loosen with thermal cycling, replace yellowed or cracked switch plates, and label the DB so the next occupant is not flipping breakers at random. In villas, add the garden circuits and the external water heater cupboards, which bake in the sun.
Where a handyman stops and an approved contractor begins
UAE utilities draw a firm line through every home. DEWA, SEWA, ADDC and Etihad WE own and control everything up to and including the meter; nobody you hire may touch it, and a damaged meter seal alone can trigger penalties. Beyond the meter, the rule of thumb is that like-for-like work is handyman territory while anything that changes the installation needs a contractor holding the relevant utility approval: replacing or upgrading the DB itself, adding new circuits, rewiring, increasing the connected load for a bigger AC or an EV charger, or anything the utility must inspect and reconnect.
Handyman-level work, which most tamam electrical bookings fall into, covers fault finding, socket and switch replacement, adding a socket as a spur on an existing circuit, light fixture and fan installation, water heater replacement on an existing point, and appliance connections. The technician should still be a trained electrician; handyman-level describes the regulatory weight of the job, not the skill it needs.
Frequently asked questions
Why does my breaker trip every time it rains or the humidity spikes?
Moisture is getting into an outdoor fitting, balcony socket, external water heater cupboard or garden joint and leaking current to earth, which the RCD correctly detects. It feels random because it follows weather, not usage. An electrician isolates circuits at the DB and tests insulation resistance to find the wet point, then re-terminates it in a properly sealed enclosure.
Can a handyman add a new socket, or does that need DEWA approval?
A socket added as a spur from an existing nearby circuit is handyman-level work and needs no utility involvement, though in a rental you need landlord permission for anything cut into walls. A new circuit from the DB, a board upgrade or an increase in connected load crosses into approved-contractor territory with DEWA, SEWA, ADDC or Etihad WE, depending on your emirate.
How long does light fixture installation take, and can I supply my own fixture?
A standard fixture on a normal ceiling takes thirty to sixty minutes; chandeliers with assembly and high ceilings can run to two or three hours. Supplying your own fixture is normal and usually cheaper, just have it on site before the visit and mention ceiling height and material, since concrete slab and gypsum need different fixings.
What is an RCD, and why does mine trip when the washing machine runs?
An RCD cuts power within milliseconds when current leaks to earth, which is what stops a faulty appliance from electrocuting someone. Washing machines trip it when their heating element's insulation degrades, a very common failure in the UAE's hard water conditions. The fix is repairing or replacing the appliance, never swapping the RCD for a less sensitive one.
How do I know the electrician I am booking is actually qualified?
Legitimate operators work under a licensed company rather than as anonymous freelancers, and for regulated work they should name their utility approval without being pressed. Booking through tamam adds a layer, since listed vendors are verified and the job, payment and history are recorded in the app, which also makes it easy to rebook the same technician who already knows your board.
Do you cover Al Markaziyah East?
We cover Al Markaziyah East and the surrounding Abu Dhabi communities. Message on whatsapp if you want a specific time confirmed first.