For anyone arranging car detailing around Aljada, tamam removes the two annoying parts — finding someone trustworthy, and finding out the price before they arrive.
Download the appBook on WhatsAppAljada sits within Sharjah, and local conditions do influence car detailing: access procedures, building rules and seasonal demand all shift how a booking should be planned.
Vendor availability is steady and lead times are typically short. 3–8 hours is the usual window for interior detailing; larger properties or added scope push it out.
Leather, trim, headliner and deep vacuum.
interior detailing generally falls in the AED 300–2500 band. Comparing several verified vendors on the same job description is what stops you overpaying.
As a rough guide for interior detailing: ceramic coating including prep and correction around AED 1,000–2,500; partial-front ppf (bumper and bonnet leading edge) around AED 1,200–2,500; interior deep clean with leather treatment around AED 300–800.
You will see each vendor's price against your job description, then decide. No commitment until then.
A serious detailer does not quote a paint correction from a photo. The first diagnostic is a paint depth gauge — a small ultrasonic or magnetic device pressed against each panel that reads total paint thickness in microns. Factory paint typically reads 100–160 microns. A panel reading 250 microns has been resprayed; a panel reading 80 has probably been machine-polished hard before and has little clearcoat left to work with. Correcting paint means removing clearcoat, so knowing how much remains is the difference between a safe polish and striking through to the colour coat.
The second check is contamination. The detailer runs a hand — often inside a thin plastic bag, which amplifies texture — across the paint. Paint that feels gritty rather than glass-smooth is carrying bonded contamination: industrial fallout, brake dust particles, tar, and in the UAE, mineral deposits from hard water and the occasional cement overspray from the construction site next door. None of that comes off in a wash, and polishing over it drags the particles around, so it dictates a decontamination stage before any machine work.
Coverage is where quotes diverge. A partial-front kit — front bumper, headlights, and the leading third of the bonnet and wings — targets the zones that collect most of the chip damage and is the rational choice for most highway commuters. Full-front and full-body coverage exist for new and high-value cars, priced well above the typical detailing bracket. The failure modes to ask about are edge lifting and yellowing: cheap films yellow under UV within a couple of years, and poor installation shows as visible seams, stretched patterns and dirt trapped under edges. Ask whether edges are wrapped around the panel or trimmed on the paint, and what the film warranty actually covers in writing.
PPF and ceramic are complements, not rivals — many owners film the impact zones and coat the whole car, since coating over PPF keeps the film itself easier to wash and slows its UV ageing. If the budget only stretches to one, let your driving decide: mostly urban, garage-parked, cosmetics-driven points to correction plus coating; a daily 100 km highway run points to film on the front end first.
Timing matters in this climate specifically. Spraying cold water across an engine that has been heat-soaked to UAE summer temperatures thermally shocks plastics and can crack a hot exhaust manifold coating; the job should be done on a cool engine, which in July effectively means first thing in the morning or after hours parked in shade. Afterwards, a water-based dressing on the plastics restores the factory look — solvent and silicone dressings in a bay that runs at high temperature just bake off and smoke.
If a mobile detailer proposes to pressure-wash your engine bay in your building's car park, decline. Beyond the electrical risk, most Dubai and Abu Dhabi tower car parks prohibit runoff-producing work, and degreaser runoff is exactly what building management fines residents for. A steam-based bay clean, or doing that one item at a workshop, sidesteps both problems.
whatsapp is the shortcut when the job is unusual, urgent, or you simply want a human to sort it.
Every vendor on tamam has a verified trade licence with the relevant municipality, checked insurance, and technicians who are ID-tagged in the app.
A coating is transparent and permanent enough to be annoying: it seals in every swirl and etch mark beneath it. The suspiciously cheap coating deals almost always skip decontamination and polishing, which is precisely where the labour cost lives. Pay for the prep or skip the coating.
Water driven past connector seals into coils, the alternator or fuse boxes causes faults that surface days later as corrosion develops, which is why the damage rarely gets connected to the wash. Bays need degreaser, brushes, covered electronics and low pressure or steam — a job for someone who has done it a few hundred times.
Every machine polish removes clearcoat, and clearcoat is a finite budget of roughly 40–60 microns for the car's whole life. Cars that get 'a quick buff' at every service end up with thin, UV-vulnerable paint within a few years. Protect more, polish less: correction should be an occasional reset, not routine maintenance.
Not pointless, but short-lived. Carnauba-based waxes soften at temperatures a UAE bonnet exceeds daily in summer, so expect four to eight weeks of protection rather than the months you would get in Europe. On a garaged car, or as a cheap top-up over an existing coating, wax still has a role.
The case weakens considerably. PPF's main job in the UAE is absorbing highway gravel strikes and sand abrasion at speed. For an urban, garage-kept car, a correction plus ceramic coating typically delivers more visible benefit per dirham. If you do a daily E311, E611 or inter-emirate run, partial-front film is one of the most rational protection spends available.
Done properly, no — done with an open pressure washer, possibly. The professional method covers the battery, alternator, fuse box and air intake, uses degreaser with brushes and only low-pressure water or steam, and works on a cool engine. Water forced into connectors can cause misfires that appear days later, which is why method matters more than products here.
A sensible rhythm is a proper maintenance wash every one to two weeks, a decontamination and interior deep clean every three to six months, and machine polishing only when the paint actually needs it — typically once a year at most, since every polish spends clearcoat. Coated cars stretch these intervals because contamination bonds less readily.
Correct first, then coat. A ceramic coating is transparent and locks in whatever is under it, so coating over swirls preserves them under a hard layer that is tedious to polish through later. This is why reputable coating packages include at least a single-stage polish, and why suspiciously cheap coating offers usually skip it.
We cover Aljada and the surrounding Sharjah communities. Message on whatsapp if you want a specific time confirmed first.
interior detailing elsewhere in sharjah
more car detailing in aljada
other car services in aljada
Two ways in: the app for comparison and tracking, whatsapp if you would rather just talk to someone.
Get the tamam appMessage on WhatsApp