ttamamusually replies in minutes11:07
pinnedfrom AED 100–500visit length 1–3 hourslocation Mankhool, Dubaivendors verified
need furniture assembly in mankhool — today if possible11:07✓✓
For anyone arranging handyman around Mankhool, tamam removes the two annoying parts — finding someone trustworthy, and finding out the price before they arrive.11:08
typical ranges vendors quote around mankhool —TV mounting up to 65 inches (bracket supplied by customer)AED 150–350Curtain rail or blind installation, per windowAED 100–250Flat-pack assembly, standard bed or chest of drawersAED 150–30011:09
that works. who actually turns up?11:10✓✓
licensed vendors only — the licence and vendor ID land in this chat before anyone rings your bell.11:11
TV mounting: forget the stud finder you saw on YouTube
Most TV-mounting advice online is written for North American timber-frame houses. UAE apartments and villas are built differently: exterior and structural walls are concrete block or poured concrete finished with plaster, while many internal partitions, especially in towers built after roughly 2005, are gypsum board on light-gauge metal studs. A timber stud finder is useless here. The professional method is a knock test first (block sounds dead, gypsum sounds hollow), then a magnet or metal-stud detector to map the studs at their usual 400 or 600 millimetre spacing.
On block or concrete, the job is straightforward: a hammer drill with a 6 or 8 millimetre masonry bit, nylon plugs matched to the screw, and the bracket pulls up rock solid. Expect 45-60 minutes for a fixed or tilting mount up to 65 inches, including unboxing, levelling and cable tidy-up. On gypsum, the calculus changes. A fixed mount for a mid-size TV can go onto heavy-duty toggle anchors spread across the plate, but a full-motion articulating arm concentrates leverage onto a few fixing points, and on gypsum that demands hitting at least two metal studs or, better, fitting a plywood backing board first. A technician who proposes screwing a swing arm straight into plasterboard with plastic plugs is telling you they have not done this long.
Judging the finished work: the five-minute walkthrough before the van leaves
Every job in this guide has an objective pass test, and the time to apply it is while the technician is still in your home. Pull firmly on every bracket, rail and mount, a proper fixing does not move at all, and a professional will do this pull test in front of you without being asked. Sight along rails and frames or ask for the laser to be held up one last time. Open and close every adjusted door at normal speed. Run a finger along silicone lines to check the edges are bonded (gently, and only if the bead has skinned). Count the holes: there should be exactly as many as there are fixings, and any abandoned holes should have been filled before the tools were packed.
Then look down. Dust and packaging are part of the job, not your problem after it: block-drilling dust vacuumed rather than swept into grout lines, cardboard and offcuts removed, protective film peeled off new hardware. Take photos of the finished work while everything is fresh, they are useful if anything settles or loosens in the first weeks.
What it costs
Pricing for furniture assembly in Mankhool moves with the size of the job, the vendor tier you choose, and any parts or consumables involved. tamam shows AED ranges before you book rather than one fixed number.
TV mounting up to 65 inches (bracket supplied by customer)AED 150–350
Curtain rail or blind installation, per windowAED 100–250
Flat-pack assembly, standard bed or chest of drawersAED 150–300
Full shower or bathroom silicone resealAED 200–400
Half-day multi-job or move-in snag visitAED 300–500
You will see each vendor's price against your job description, then decide. No commitment until then.
Frequently asked questions
Do handymen bring their own tools and materials?
Tools, yes, always: drills, levels, anchors and consumables like screws and basic plugs are part of the service. Specific hardware is different: TV brackets, curtain rails, mirrors, shelves and replacement hinges are normally customer-supplied unless the quote says otherwise. Confirm the split when you accept the quote so nobody is standing in a hardware store mid-visit.
Can a handyman do electrical or plumbing work?
Only at fixture level: swapping a light fitting, changing a tap washer, fitting an appliance. New wiring, new power points, anything at the distribution board, or work on supply pipework needs a licensed electrician or plumber under DEWA, SEWA or ADDC and municipality rules. A good handyman will tell you where that line is rather than crossing it.
What happens if the job takes longer than quoted?
It depends on whether the scope changed. If you added tasks on the day, expect the price to move, agree the addition before the extra work starts. If the scope is unchanged and the technician simply underestimated, a fixed quote should hold, which is one reason to get quotes against a full photo-documented list rather than a vague description.
Can a handyman fix the snags in my brand-new apartment?
They can, but often should not, yet. Genuine construction defects belong on the developer's snag list inside the defects liability period, usually twelve months, and fixing them privately can weaken your claim. Document defects with the developer first, then use a handyman for everything the developer never owed you: mounting, rails, assembly and the move-in list.
Do handymen work weekends and evenings in the UAE?
Most vendors work Saturdays and many work Sundays, which suits commuting households, but tower rules can override this: plenty of buildings ban drilling on weekends or after 6pm. Quiet jobs, assembly, silicone, door adjustment, are usually fine any day. Check your building's noisy-work hours before booking a weekend slot.
Do you cover Mankhool?
Mankhool is within our Dubai coverage. Open the app to see which vendors have slots near you today.
Avoid these
Letting anyone seal over old silicone
New silicone does not bond to old silicone, and mould trapped underneath grows straight through the fresh bead. If the technician is not spending most of the job on removal and drying, the reseal will fail within months. Ask to see the joint clean and dry before the new bead goes in.
Putting a full-motion TV arm into bare plasterboard
An articulating arm multiplies the TV's weight into leverage at a few fixing points, and plastic plugs in gypsum cannot resist it. The mount holds during the demo and fails weeks later. Insist on metal studs, a backing board, or a different wall.
Skipping the building permit and losing the slot
In permit-controlled towers, a technician stopped at security is a wasted visit that you may still be charged for. Five minutes with building management before booking, asking about NOCs, service-lift rules and drilling hours, protects both your slot and your deposit with the building.