ttamamusually replies in minutes11:07
pinnedfrom AED 100–500visit length 1–3 hourslocation Limestone House, Dubaivendors verified
need door repair in limestone house — today if possible11:07✓✓
For anyone arranging handyman around Limestone House, tamam removes the two annoying parts — finding someone trustworthy, and finding out the price before they arrive.11:08
typical ranges vendors quote around limestone house —Standard call-out including first hour of labourAED 100–200TV mounting up to 65 inches (bracket supplied by customer)AED 150–350Flat-pack assembly, standard bed or chest of drawersAED 150–30011:09
that works. who actually turns up?11:10✓✓
licensed vendors only — the licence and vendor ID land in this chat before anyone rings your bell.11:11
Anatomy of a call-out: what happens between the doorbell and the invoice
Next comes scope confirmation. The technician restates what will be done, what materials are needed, and whether anything on your list is actually outside a handyman's lane, wiring a new power point, for example, belongs to a licensed electrician under DEWA and municipality rules, and a good handyman says so rather than improvising. Then protection goes down: drop sheets under drilling points, and ideally a vacuum or dust catcher held at the drill hole, because red block dust stains light grout and carpet.
The work itself follows the sequence agreed, and the visit ends with a walkthrough in reverse: every fixing gets a firm pull test, levels go back on the shelves and frames, offcuts and packaging leave with the technician, and you check each item against your original list. Most call-outs in the UAE carry a minimum charge, typically AED 100-200, which usually covers arrival and the first block of labour. That minimum is exactly why batching several small jobs into one visit is the single best money decision in this trade, more on that below.
Doors that stick, slam or will not latch: humidity plus air conditioning
UAE doors misbehave for two local reasons. First, humidity: timber doors swell through the humid months, roughly June to September on the coast, and a door that fit perfectly in February starts scraping its frame in August. Second, air pressure: a closed apartment with the AC running sits at a slightly different pressure to the corridor, which is why doors slam themselves or refuse to close that final centimetre. Diagnosis comes before tools: a pro closes the door slowly, watches where the gap tightens, and checks the hinge screws before assuming the door needs planing.
Nine times out of ten the fix is at the hinge. Years of use strip the top hinge screws out of the frame, letting the door drop and bind at the latch corner. The repair sequence is: remove the stripped screws, plug the holes with glued hardwood dowels or fit longer screws that reach the wall structure behind the frame, and re-hang. If the door still binds after the hinges are true, then and only then does the plane or belt sander come out, taken to the bottom or latch edge in light passes, with the bare timber resealed afterwards so it does not just swell again next summer. Latch problems usually need nothing more than moving the strike plate a couple of millimetres.
Snag lists and new handovers: working a punch list like a site manager
If you have just taken handover of a new apartment or villa, you have two overlapping jobs and they should not be confused. Defects that are the developer's responsibility, cracked tiles, failed grout, misaligned kitchen doors, paint defects, belong on the official snag report inside the defects liability period, typically twelve months from handover in the UAE. Fixing those yourself, or having a handyman fix them, can muddy your claim, so document first: photograph everything, log it with the developer or their facilities company, and let their contractor close what they are obliged to close.
For a full move-in list, a half-day booking (around AED 300-500 in most of the market) is far better value than three separate call-outs, and it is where an organised customer saves real money. Send the full list with photos when you request quotes, vendors on tamam can price a batched visit properly only if they can see the whole scope, and a vague 'a few small jobs' brief reliably produces either an inflated quote or a second visit.
What you should expect to pay
There is no single correct price for door repair — there is a range, and where you land in it depends on scope and which vendor you pick. The app shows you that range up front.
Standard call-out including first hour of labourAED 100–200
TV mounting up to 65 inches (bracket supplied by customer)AED 150–350
Flat-pack assembly, standard bed or chest of drawersAED 150–300
Door realignment and hinge repair, per doorAED 100–200
Half-day multi-job or move-in snag visitAED 300–500
What you finally pay depends on the vendor and tier you choose — all of it visible before booking.
What goes wrong
Letting anyone seal over old silicone
New silicone does not bond to old silicone, and mould trapped underneath grows straight through the fresh bead. If the technician is not spending most of the job on removal and drying, the reseal will fail within months. Ask to see the joint clean and dry before the new bead goes in.
Skipping the building permit and losing the slot
In permit-controlled towers, a technician stopped at security is a wasted visit that you may still be charged for. Five minutes with building management before booking, asking about NOCs, service-lift rules and drilling hours, protects both your slot and your deposit with the building.
Fixing developer defects at your own cost
Cracked tiles, failed grout and misaligned kitchen units in a new handover are usually the developer's obligation during the defects liability period. Paying a handyman to fix them both costs you money and can undermine the official snag claim. Document and report first; hire for the jobs the developer never owed you.
Frequently asked questions
Do handymen bring their own tools and materials?
Tools, yes, always: drills, levels, anchors and consumables like screws and basic plugs are part of the service. Specific hardware is different: TV brackets, curtain rails, mirrors, shelves and replacement hinges are normally customer-supplied unless the quote says otherwise. Confirm the split when you accept the quote so nobody is standing in a hardware store mid-visit.
Can a handyman do electrical or plumbing work?
Only at fixture level: swapping a light fitting, changing a tap washer, fitting an appliance. New wiring, new power points, anything at the distribution board, or work on supply pipework needs a licensed electrician or plumber under DEWA, SEWA or ADDC and municipality rules. A good handyman will tell you where that line is rather than crossing it.
Can I hang a heavy mirror on a gypsum wall?
Yes, if it is fixed correctly. Light frames go on plasterboard anchors, but a heavy mirror needs to land on the metal studs behind the board or use rated cavity fixings across multiple points. If the technician cannot tell you which method they are using and why, pause the drilling.
How long before I can use the shower after silicone resealing?
Roughly 24 hours. Sanitary silicone skins quickly but needs a full day to cure; running the shower the same evening washes out the bead and shortens its life dramatically. Book the reseal for a morning and plan around the guest bathroom that day.
Is it cheaper to combine several small jobs in one visit?
Significantly. The call-out minimum, typically AED 100-200, is charged per visit, so five separate bookings pay that floor five times. A batched list turns the same jobs into one half-day visit around AED 300-500, and vendors quote batched work more keenly because the travel is amortised.
Do you cover Limestone House?
Yes — Limestone House is covered across Dubai, with vendors who regularly work the area. Availability shows live in the app.