the going rate · sharjah
ranges are typical · live quotes in chat
tamam connects Sharjah Garden City households and businesses with vetted handyman providers. You see the options, the AED range and the availability, then book directly.
one meter · three job sizes
The character of Sharjah Garden City — primarily residential, so most bookings are villa or apartment work and timing follows family routines — determines what a good handyman visit looks like here, from the equipment brought to the slot that gets chosen.
Vendor availability is steady and lead times are typically short. Budget roughly 1–3 hours on site for curtain installation, plus a little for access if the building has a lift protocol.
Rails and tracks drilled level, blackout and sheer layers hung.
Next comes scope confirmation. The technician restates what will be done, what materials are needed, and whether anything on your list is actually outside a handyman's lane, wiring a new power point, for example, belongs to a licensed electrician under DEWA and municipality rules, and a good handyman says so rather than improvising. Then protection goes down: drop sheets under drilling points, and ideally a vacuum or dust catcher held at the drill hole, because red block dust stains light grout and carpet.
The work itself follows the sequence agreed, and the visit ends with a walkthrough in reverse: every fixing gets a firm pull test, levels go back on the shelves and frames, offcuts and packaging leave with the technician, and you check each item against your original list. Most call-outs in the UAE carry a minimum charge, typically AED 100-200, which usually covers arrival and the first block of labour. That minimum is exactly why batching several small jobs into one visit is the single best money decision in this trade, more on that below.
Blackened silicone around a shower tray or kitchen sink is probably the most common small job in UAE bathrooms, and it is also the most commonly botched, because the visible part (running a new bead) is the quick part. The job is really a removal job. Every trace of the old sealant has to come out: cut free with a blade, scraped, then the residue dissolved or abraded away, because new silicone will not bond to old silicone and any mould left in the joint grows straight through the fresh bead within months.
The surface then has to be genuinely dry, not towel-dry but dry-dry, which in a family bathroom means the shower is out of use for a few hours before the work, worth knowing when you schedule the visit. The pro then masks both sides of the joint with tape, guns a sanitary-grade anti-fungal silicone (not general-purpose acrylic, which is cheaper and fails fast in wet areas), tools the bead smooth in one pass, and pulls the tape while the bead is wet, leaving those crisp straight edges that separate professional work from a DIY afternoon.
The surprise is hollow block, common in older and mid-market buildings across the northern emirates and in plenty of Dubai and Sharjah stock from the 1990s and 2000s. The drill punches through the block face into a void, the plug spins uselessly, and an inexperienced installer just moves over ten centimetres and tries again, leaving a trail of holes. The correct answers are longer plugs that grip the far face, umbrella-style cavity fixings, or for heavy mirrors and cabinets, a chemical anchor with a mesh sleeve that mushrooms resin inside the void. This is exactly the kind of judgement you are paying a professional call-out for.
For gallery walls and multi-frame layouts, watch for the laser line. A cross-line laser plus paper templates taped up for approval before drilling turns a two-hour trial-and-error session into forty minutes with zero spare holes. Good finish standard: frames level and aligned to the laser, no cracked plaster around fixing points, and every anchor flush, not proud of the wall.
Sharjah's rental stock skews toward 1990s and 2000s mid-rise buildings, which is exactly where hollow-block walls are most common, brief your technician if a previous hanging attempt produced spinning plugs, because it changes the anchor plan. SEWA governs utilities, and anything beyond fixture-level electrical or plumbing work needs a licensed contractor. Family-occupied buildings in areas like Al Nahda and Al Majaz often have house rules about worker access hours and advance notice to the watchman, so confirm access before the visit. Sharjah is also a strong market for batched half-day visits, since many residents commute to Dubai and want everything done in one scheduled window.
Trade licences are checked against the issuing municipality, not self-declared, and insurance has to be current for a vendor to stay listed.
The honest answer on cost is a range, not a figure. For curtain installation the typical band is AED 100–500, and you see each vendor's position in it before committing.
Booking takes about a minute. Rebooking takes a couple of taps.
New silicone does not bond to old silicone, and mould trapped underneath grows straight through the fresh bead. If the technician is not spending most of the job on removal and drying, the reseal will fail within months. Ask to see the joint clean and dry before the new bead goes in.
In permit-controlled towers, a technician stopped at security is a wasted visit that you may still be charged for. Five minutes with building management before booking, asking about NOCs, service-lift rules and drilling hours, protects both your slot and your deposit with the building.
The cheapest quote often prices a different job: silicone over silicone, plugs instead of proper anchors, no anti-tip strap on the wardrobe. When quotes differ widely, ask each vendor how they will do the job. The one who mentions wall type, anchors and cure times without prompting is usually the one worth paying.
Yes, if it is fixed correctly. Light frames go on plasterboard anchors, but a heavy mirror needs to land on the metal studs behind the board or use rated cavity fixings across multiple points. If the technician cannot tell you which method they are using and why, pause the drilling.
In many Dubai and Abu Dhabi towers and masterplanned communities, yes: management requires a work permit or NOC, and often restricts noisy work to set weekday hours. Villas and most older buildings need nothing formal beyond a word with the watchman. Check with your building before booking, because a technician turned away at security still counts as a visit.
Roughly 24 hours. Sanitary silicone skins quickly but needs a full day to cure; running the shower the same evening washes out the bead and shortens its life dramatically. Book the reseal for a morning and plan around the guest bathroom that day.
They can, but often should not, yet. Genuine construction defects belong on the developer's snag list inside the defects liability period, usually twelve months, and fixing them privately can weaken your claim. Document defects with the developer first, then use a handyman for everything the developer never owed you: mounting, rails, assembly and the move-in list.
Most vendors work Saturdays and many work Sundays, which suits commuting households, but tower rules can override this: plenty of buildings ban drilling on weekends or after 6pm. Quiet jobs, assembly, silicone, door adjustment, are usually fine any day. Check your building's noisy-work hours before booking a weekend slot.
Sharjah Garden City is within our Sharjah coverage. Open the app to see which vendors have slots near you today.
Booking takes about a minute. Rebooking takes a couple of taps.