ttamamusually replies in minutes11:14
pinnedfrom AED 100–500visit length 1–3 hourslocation Nad Al Sheba 4, Dubaivendors verified
need curtain installation in nad al sheba 4 — today if possible11:14✓✓
Nad Al Sheba 4 sits in Dubai, and handyman here has its own rhythm: access rules, parking, and timing that a vendor who knows the area already understands.11:15
typical ranges vendors quote around nad al sheba 4 —Standard call-out including first hour of labourAED 100–200TV mounting up to 65 inches (bracket supplied by customer)AED 150–350Curtain rail or blind installation, per windowAED 100–25011:16
that works. who actually turns up?11:17✓✓
licensed vendors only — the licence and vendor ID land in this chat before anyone rings your bell.11:18
The kit in the van: what a properly equipped handyman carries
You can read a technician's standards from their kit before they touch a wall. The baseline for UAE work is a cordless hammer drill with masonry, wood and metal bits; a drill-driver with a clutch for flat-pack work; a cross-line laser and a traditional spirit level; a metal-stud detector and a strong magnet; and an anchor box that covers the local reality, nylon plugs in several sizes, plasterboard self-drives, toggles, cavity fixings and at least a few chemical-anchor options for hollow block.
The finishing and protection layer matters just as much: drop sheets, masking tape, a handheld vacuum or dust-catch attachment, sanitary silicone with a proper gun and tooling kit, hardwood dowels and wood glue for stripped hinges, and a step platform or ladder rated for ceiling work. What the technician usually does not carry is your specific hardware: TV brackets, curtain rails, mirrors and shelves are normally customer-supplied unless you agree otherwise in the quote, so confirm who buys what before the visit, not at your doorstep.
Judging the finished work: the five-minute walkthrough before the van leaves
Every job in this guide has an objective pass test, and the time to apply it is while the technician is still in your home. Pull firmly on every bracket, rail and mount, a proper fixing does not move at all, and a professional will do this pull test in front of you without being asked. Sight along rails and frames or ask for the laser to be held up one last time. Open and close every adjusted door at normal speed. Run a finger along silicone lines to check the edges are bonded (gently, and only if the bead has skinned). Count the holes: there should be exactly as many as there are fixings, and any abandoned holes should have been filled before the tools were packed.
Then look down. Dust and packaging are part of the job, not your problem after it: block-drilling dust vacuumed rather than swept into grout lines, cardboard and offcuts removed, protective film peeled off new hardware. Take photos of the finished work while everything is fresh, they are useful if anything settles or loosens in the first weeks.
What you should expect to pay
There is no single correct price for curtain installation — there is a range, and where you land in it depends on scope and which vendor you pick. The app shows you that range up front.
Standard call-out including first hour of labourAED 100–200
TV mounting up to 65 inches (bracket supplied by customer)AED 150–350
Curtain rail or blind installation, per windowAED 100–250
Large wardrobe assembly with anti-tip anchoringAED 250–500
Door realignment and hinge repair, per doorAED 100–200
You will see each vendor's price against your job description, then decide. No commitment until then.
Frequently asked questions
Do handymen bring their own tools and materials?
Tools, yes, always: drills, levels, anchors and consumables like screws and basic plugs are part of the service. Specific hardware is different: TV brackets, curtain rails, mirrors, shelves and replacement hinges are normally customer-supplied unless the quote says otherwise. Confirm the split when you accept the quote so nobody is standing in a hardware store mid-visit.
Can a handyman do electrical or plumbing work?
Only at fixture level: swapping a light fitting, changing a tap washer, fitting an appliance. New wiring, new power points, anything at the distribution board, or work on supply pipework needs a licensed electrician or plumber under DEWA, SEWA or ADDC and municipality rules. A good handyman will tell you where that line is rather than crossing it.
Can I hang a heavy mirror on a gypsum wall?
Yes, if it is fixed correctly. Light frames go on plasterboard anchors, but a heavy mirror needs to land on the metal studs behind the board or use rated cavity fixings across multiple points. If the technician cannot tell you which method they are using and why, pause the drilling.
How long before I can use the shower after silicone resealing?
Roughly 24 hours. Sanitary silicone skins quickly but needs a full day to cure; running the shower the same evening washes out the bead and shortens its life dramatically. Book the reseal for a morning and plan around the guest bathroom that day.
What happens if the job takes longer than quoted?
It depends on whether the scope changed. If you added tasks on the day, expect the price to move, agree the addition before the extra work starts. If the scope is unchanged and the technician simply underestimated, a fixed quote should hold, which is one reason to get quotes against a full photo-documented list rather than a vague description.
Do you cover Nad Al Sheba 4?
Yes — Nad Al Sheba 4 is covered across Dubai, with vendors who regularly work the area. Availability shows live in the app.
Mistakes to avoid
Booking one small job at a time
Every visit carries the call-out minimum, so three single-job bookings can cost more than one half-day visit that clears ten jobs. Keep a running list on your phone and book when it reaches three or four items. Vendors also quote batched work more competitively because their travel time is spread across more billable tasks.
Letting anyone seal over old silicone
New silicone does not bond to old silicone, and mould trapped underneath grows straight through the fresh bead. If the technician is not spending most of the job on removal and drying, the reseal will fail within months. Ask to see the joint clean and dry before the new bead goes in.
Putting a full-motion TV arm into bare plasterboard
An articulating arm multiplies the TV's weight into leverage at a few fixing points, and plastic plugs in gypsum cannot resist it. The mount holds during the demo and fails weeks later. Insist on metal studs, a backing board, or a different wall.