ttamamusually replies in minutes11:35
pinnedprice band AED 150–600duration 1–3 hourscovers Yas Islandemirate Abu Dhabi
need ceiling fan installation in yas island — today if possible11:35✓✓
Getting electrician done in Yas Island shouldn't involve three phone calls and a guessed price. Open tamam, compare verified vendors, pick your slot, done.11:36
typical ranges vendors quote around yas island —Call-out with fault diagnosis (tripping breaker, dead circuit)AED 150–250New socket point as a spur on an existing circuitAED 180–350Chandelier installation with assembly, high ceilingAED 350–60011:37
that works. who actually turns up?11:38✓✓
licensed vendors only — the licence and vendor ID land in this chat before anyone rings your bell.11:39
The landlord between tenants: a two-hour audit that prevents deposit disputes
The gap between tenancies is the only time you have an empty unit, full access and no one to inconvenience, which makes it the cheapest possible moment to deal with electrical wear. Faults found now cost a call-out; the same faults found by an unhappy tenant in month two cost a call-out plus an argument about liability, and unresolved snags are a recurring theme in deposit disputes at the rental committees.
A competent electrician can audit a one- or two-bedroom flat in a couple of hours: test every socket with a tester, press-test each RCD, check water heater elements for earth leakage before they become the next tenant's mystery trip, tighten DB terminals that loosen with thermal cycling, replace yellowed or cracked switch plates, and label the DB so the next occupant is not flipping breakers at random. In villas, add the garden circuits and the external water heater cupboards, which bake in the sun.
What you should expect to pay
ceiling fan installation generally falls in the AED 150–600 band. Comparing several verified vendors on the same job description is what stops you overpaying.
Call-out with fault diagnosis (tripping breaker, dead circuit)AED 150–250
New socket point as a spur on an existing circuitAED 180–350
Chandelier installation with assembly, high ceilingAED 350–600
RCD or breaker replacement in the DBAED 200–450
Villa landscape lighting repair visitAED 250–550
Parts and consumables, where they apply, are quoted separately and approved by you first.
Avoid these
Resetting a tripping breaker over and over without finding the cause
A breaker that keeps dropping is doing its job; the fault is still there. Repeated forced resets stress the breaker and, in worn boards, can overheat the buswork behind it. Reset once after unplugging the circuit's appliances; if it will not hold, stop and book a diagnosis.
Buying the appliance or fixture before checking the ceiling or the board
The induction hob that needs a dedicated circuit your DB cannot spare, the chandelier your gypsum ceiling cannot carry, the dimmer your LED lamps do not support: all cheaper to discover before purchase. A short survey visit or even photos sent ahead prevents owning hardware you cannot install.
Booking tower work without checking permit rules first
Many managed buildings turn contractors away without a work permit or landlord NOC, and some restrict noisy work to weekday hours. The result is a paid visit that ends in the lobby. One message to building management before you pick a slot avoids the wasted call-out.
Frequently asked questions
My whole flat lost power but the neighbours are fine. Who do I call?
First check your own DB: if the main isolator or RCD has dropped, reset it once. If the board is fully on but the flat is dead, the fault is likely at the meter or the building's riser, which is the utility's or building management's side. Call the building's maintenance desk or the utility's fault line; a private electrician cannot legally open that part of the installation.
Do I have to pay for electrical repairs in my rented apartment?
Check your tenancy contract for a minor-maintenance clause; the common UAE arrangement makes tenants responsible for small repairs up to a stated amount per incident, with the landlord covering wear-and-tear and anything structural. An aging water heater leaking to earth is wear, not misuse, so document faults with photos and dates before agreeing to pay.
Are my 110V appliances from the US safe to use here?
Not directly. The UAE supply is 220–240V, and plugging a 110V appliance in without a step-down transformer will damage it, often immediately. Small dual-voltage electronics like laptop chargers are fine with a plug adapter, but motors, kitchen appliances and anything with a heating element need a correctly rated transformer or, more sensibly, a local replacement.
How do I know the electrician I am booking is actually qualified?
Legitimate operators work under a licensed company rather than as anonymous freelancers, and for regulated work they should name their utility approval without being pressed. Booking through tamam adds a layer, since listed vendors are verified and the job, payment and history are recorded in the app, which also makes it easy to rebook the same technician who already knows your board.
Is it worth adding RCD protection to an older building's board?
Yes, and it is one of the cheapest safety upgrades available. Many pre-2000s buildings in Deira, Ajman and UAQ still have boards with MCBs only, meaning nothing detects earth leakage from a failing heater or damaged cable. Adding RCD protection is a board-level job, so use a properly licensed electrician and expect a short power shutdown during the work.
Do you cover Yas Island?
Yes — Yas Island is covered across Abu Dhabi, with vendors who regularly work the area. Availability shows live in the app.