ac duct cleaningin masfout.

Before you book anyone, work out which of three systems you live with, because the technician's scope differs completely. Villas and townhouses almost always use DX (direct expansion) systems: wall splits, or a ducted split with the air handler above a corridor ceiling and condensers on the roof. Here you own the whole refrigeration loop. Most apartment towers in Dubai Marina, Downtown, JLT, Business Bay and Al Reem use chilled water instead: a plant — the building's own, or a district cooling provider such as Empower or Tabreed — chills water centrally and pumps it to a fan coil unit (FCU) above your ceiling. There is no refrigerant in your flat at all, so nobody should ever quote you a gas top-up. What fails in an FCU is mechanical and electrical: the blower motor, the actuator valve, the thermostat, the filter and the drain pan.

The distinction matters for money as well as diagnosis. On district cooling you pay the provider for consumption and capacity, and the temperature of the water arriving at your floor is outside your technician's control. If the flat will not cool but the FCU checks out — valve opening, blower spinning, filter clean — the problem may sit at building level, which is a conversation with facilities management, not a repair bill. A good technician says this plainly instead of inventing work.

Refrigerant is not fuel. It circulates in a sealed loop and is never consumed, so a unit that needs gas has a leak — full stop. The honest version of a regas visit: find the leak with a detector or nitrogen pressure test, repair it, pull a vacuum on the lines, then weigh in the exact charge printed on the nameplate. The dishonest version is a hose, a cylinder, and see-you-next-summer. If you have paid for top-ups two years running, you have paid twice for one unfixed leak.

The gas itself matters. Older UAE units run R22 — the gas everyone still calls freon — which is being phased out under the Montreal Protocol; imports are restricted and the shrinking supply gets pricier every year, so regassing an old R22 unit can cost a startling share of its remaining value. Most systems from the last decade use R410A, and newer machines increasingly use R32, more efficient but mildly flammable. The gases are not interchangeable: R410A runs at much higher pressures than R22, so you cannot refill an old system with new gas. When a technician says an ageing R22 unit with a leaking coil is not worth repairing, the arithmetic usually supports them.

Split units in the UAE live hard lives — near-continuous summer duty, corrosive coastal air, dust — and ten to fifteen years is realistic, with the coast taking the lower end as salt eats condenser fins. When a major component fails, run the arithmetic: a compressor replacement on an out-of-warranty unit frequently lands within reach of a new mid-range split once gas and labour are priced in, and on an R22 unit the scales tip harder toward replacement because every future leak inherits the rising cost of a phased-out gas. Efficiency compounds the case: a modern inverter split modulates its compressor instead of slamming on and off, and against a ten-year-old fixed-speed unit the difference shows directly on a DEWA, SEWA, ADDC or EtihadWE bill through six months of heavy duty.

The rule of thumb technicians use among themselves: if the repair costs more than about half the price of an equivalent new unit and the machine is past eight years old, replace it. Below that line, repair and keep maintaining. Decide unit by unit — a villa's five condensers rarely fail on the same schedule, and replacing each as it crosses the line spreads the cost across several summers.