furniture assemblyin gateway residences.

Realistic times matter for planning your visit: a standard double bed frame takes 60-90 minutes; a chest of drawers with runners, about an hour; a large multi-door wardrobe is a two-to-four-hour job and genuinely needs two people to lift the carcass upright without racking it out of square. If a vendor quotes a six-door sliding wardrobe as a one-hour solo job, the quote is wrong and the wardrobe will show it.

The non-negotiable finish item is anti-tip anchoring. Wardrobes, bookcases and tall drawer units come with wall straps for a reason, and in a household with children they are not optional. On block walls this is a two-minute plug-and-screw; on gypsum it means finding a stud or using a toggle. A technician who leaves a two-metre wardrobe freestanding on tile, in a country where almost every floor is hard tile, has skipped the most important step of the job.

UAE doors misbehave for two local reasons. First, humidity: timber doors swell through the humid months, roughly June to September on the coast, and a door that fit perfectly in February starts scraping its frame in August. Second, air pressure: a closed apartment with the AC running sits at a slightly different pressure to the corridor, which is why doors slam themselves or refuse to close that final centimetre. Diagnosis comes before tools: a pro closes the door slowly, watches where the gap tightens, and checks the hinge screws before assuming the door needs planing.

Nine times out of ten the fix is at the hinge. Years of use strip the top hinge screws out of the frame, letting the door drop and bind at the latch corner. The repair sequence is: remove the stripped screws, plug the holes with glued hardwood dowels or fit longer screws that reach the wall structure behind the frame, and re-hang. If the door still binds after the hinges are true, then and only then does the plane or belt sander come out, taken to the bottom or latch edge in light passes, with the bare timber resealed afterwards so it does not just swell again next summer. Latch problems usually need nothing more than moving the strike plate a couple of millimetres.

Every job in this guide has an objective pass test, and the time to apply it is while the technician is still in your home. Pull firmly on every bracket, rail and mount, a proper fixing does not move at all, and a professional will do this pull test in front of you without being asked. Sight along rails and frames or ask for the laser to be held up one last time. Open and close every adjusted door at normal speed. Run a finger along silicone lines to check the edges are bonded (gently, and only if the bead has skinned). Count the holes: there should be exactly as many as there are fixings, and any abandoned holes should have been filled before the tools were packed.

Then look down. Dust and packaging are part of the job, not your problem after it: block-drilling dust vacuumed rather than swept into grout lines, cardboard and offcuts removed, protective film peeled off new hardware. Take photos of the finished work while everything is fresh, they are useful if anything settles or loosens in the first weeks.