ac duct cleaningin masafi.

Refrigerant is not fuel. It circulates in a sealed loop and is never consumed, so a unit that needs gas has a leak — full stop. The honest version of a regas visit: find the leak with a detector or nitrogen pressure test, repair it, pull a vacuum on the lines, then weigh in the exact charge printed on the nameplate. The dishonest version is a hose, a cylinder, and see-you-next-summer. If you have paid for top-ups two years running, you have paid twice for one unfixed leak.

The gas itself matters. Older UAE units run R22 — the gas everyone still calls freon — which is being phased out under the Montreal Protocol; imports are restricted and the shrinking supply gets pricier every year, so regassing an old R22 unit can cost a startling share of its remaining value. Most systems from the last decade use R410A, and newer machines increasingly use R32, more efficient but mildly flammable. The gases are not interchangeable: R410A runs at much higher pressures than R22, so you cannot refill an old system with new gas. When a technician says an ageing R22 unit with a leaking coil is not worth repairing, the arithmetic usually supports them.

You can judge a service visit by its sequence. A thorough technician starts with the story (what changed, when), then measures before touching anything: air temperature entering the return and leaving the supply. On a healthy DX system that split is roughly 8–12°C; a smaller gap points to low refrigerant or dirty coils, a bigger one with weak flow points to airflow restriction. It is a thirty-second test that converts a vague complaint into a number. Then the electrical checks: compressor amp draw against its nameplate figure, and the run capacitor's actual microfarads against its rating. Heat kills capacitors, making them the most commonly failed electrical part in UAE condensers — a AED 200–450 swap has rescued many units declared dead. On DX systems, gauges go on the service ports; on FCUs the checks shift to valve actuation, water flow and motor bearings.

Then the wet work: filter and coil condition, blower wheel, drain pan and line flushed and confirmed flowing, condenser fins washed from the inside out so dirt exits the way it came. A visit that skips the measurements and goes straight to hosing the filter is cleaning, not maintenance. Ask for the numbers — temperature split, amps, pressures — on the job report; a technician confident in the work will write them down, and the report becomes your baseline for next time.

Split units in the UAE live hard lives — near-continuous summer duty, corrosive coastal air, dust — and ten to fifteen years is realistic, with the coast taking the lower end as salt eats condenser fins. When a major component fails, run the arithmetic: a compressor replacement on an out-of-warranty unit frequently lands within reach of a new mid-range split once gas and labour are priced in, and on an R22 unit the scales tip harder toward replacement because every future leak inherits the rising cost of a phased-out gas. Efficiency compounds the case: a modern inverter split modulates its compressor instead of slamming on and off, and against a ten-year-old fixed-speed unit the difference shows directly on a DEWA, SEWA, ADDC or EtihadWE bill through six months of heavy duty.

The rule of thumb technicians use among themselves: if the repair costs more than about half the price of an equivalent new unit and the machine is past eight years old, replace it. Below that line, repair and keep maintaining. Decide unit by unit — a villa's five condensers rarely fail on the same schedule, and replacing each as it crosses the line spreads the cost across several summers.